I copied my speedo scale (tacho was already done) and k-value from old cluster and it resulted as predicted - I had the same, bit higher valueas as old octavia cluster But, as an engineer, It wasn't enough for me - as I have learned how to properly modify dump. And we can all agree, that lowered values are far more dangerous than higher values right? So I needed to tune it. On the other side, old octavia cluster was showing a bit too high (5 more 0-80, 10 more 80-end). But I found out that I had speedometer too low - from 0-60 it showed about 5km/h lower, and from 60-end 10km/h lower. Long story short: I had 1/2 FIS on my octavia mk1 with bad LCD so I decided to swap from Superb 1 with full FIS. Based on what tjwasiak said on post no #21 and some other findings, I have finally figured out how to properly rescale my cluster.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |